Diky vsetkym trom majstrom, ale zufala je toto komunita, clovek si musi vsetko vygoolit aby tomu trochu rozumel ;-] tu su odpovede aj na otazky ktore som sa hanbil polozit:
dzirky na rafku
The common bicycle size rim hole and matching nipple is 4mm. Some rim holes and nipples can be 5mm or even 6mm on ebikes or cargo bikes.
velkosti niplov
Nipples must match the spoke size, so a 12g nipple will not fit a 13g spoke and vice versa.
ake dlhe
niple potrebujem k mojim spicom
14g spokes are often fitted with silver brass 12mm long nipples which are a common size. Longer nipples are used on thicker or deeper rims.12g & 13g spokes are supplied with 14mm or 16mm long nipples.
co znamenaju tie gcka pri ciselkach
Spoke Gauge Diameter and millimetre size:
15g = 1.8mm
14g = 2.0mm
13g = 2.3mm
12g = 2.60mm
10g = 3.20mm
9g = 3.60mm
8g = 4.00mm
7g = 4.30mm
6g = 4.87mm
5g = 5.15mm
4g = 5.70mm
ako mam zistit velkost kluca co si mam kupitMeasuring required to find the correct spoke key needed.
ktory kluc si mam kupitYou will need a spoke wrench (I use a DT spoke wrench, but most people aren't ready for a $50 spoke wrench. My favorite inexpensive spoke wrench is a plastic one with a metal bit, called a "Spokey").
Ako sa robi ze
koleso je vycentrovane v osi ramu [ dovcul som si myslel ze je to funkcia centrovacieho stojanu ]
Dish Stick, a tool for checking the dish of a wheel. It has the form of a curved stick with an adjustable feeler near the middle. The two ends of the stick rest on the side of the rim, 180 degrees apart, and the feeler is adjusted to just touch the locknut or other locating surface at the axle end. The wheel is then inverted, and, if it is correctly "dished" the three points will all contact the corresponding points on the second side of the wheel.
fakt to potrebujem? Nie ...
Centering may be checked by flipping the wheel over (so the cassette is on the left, etc.). When the position of the rim between the brake shoes and frame parts remains the same after the wheel is reversed, the rim is centered. You may also check dishing by placing two piles of blocks, books etc. on a tabletop to support the rim at two places opposite one another. The distance from the tabletop to the hub locknut on the underside should be the same, no matter which side of the wheel is down.
